Steps
1. Slide the palm-rest and keyboard assembly under the display-assembly hinges.
2. Align the screw holes on the palm-rest assembly with the screw holes on the right and left display-assembly hinges.
3. Replace the four screws (M2.5x5.5) and (M2.5x5.5) that secure the left hinge to the system board and the palm-rest and
keyboard assembly.
4. Align the screw holes on the display-assembly cable holder with the screw holes on the palm-rest and keyboard assembly.
5. Connect the touchscreen cable and camera cable to the display-assembly cable .
6. Replace the two screws (M1.6x3) that secure the display-assembly cable holder to the palm-rest and keyboard assembly.
NOTE: Apply gentle torque when tightening the two screws (M1.6x3) to avoid damaging the screw threads.
7. Align the screw holes on the display-assembly cable bracket with the screw holes on the system board.
8. Tighten the three captive screws that secure the display-assembly cable bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
42
Removing and installing components
To Next Page
Loading...
