Removing the System Board
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) cover
b) front bezel
c) optical drive
d) drive cage
e) memory
f) heat sink assembly
g) expansion card(s)
h) power supply
3. Disconnect all the cables connected to the system board, and move the cables away from the chassis.
4. Remove the screws that secure the system board to the chassis.
5. Turn the hex screw counter clockwise and remove from the system board.
6. Remove the system board from the chassis.
Installing the System Board
1. Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
2. Tighten the screws securing the system board to the chassis.
3. Connect the cables to the system board.
4. Install the:
a) power supply
b) expansion card(s)
c) heat sink assembly
d) memory
e) drive cage
f) optical drive
29
To Next Page
Loading...
