Installing the Optical Drive
1. Lift the release latch, and slide the optical-drive cage inside the compartment.
2. Press on the clasp to release the latch and thread the cables into the holder.
3. Connect the power cable to the back of the optical drive.
4. Connect the data cable to the back of the optical drive.
5. Install the cover.
6. Follow the procedures in
After Working Inside Your Computer
.
Removing the Thermal Sensor
NOTE: The thermal sensor is an optional component and your computer may not ship with it.
1. Follow the procedures in
Before Working On Your Computer
.
2. Remove the cover.
3. Open the latch securing the thermal sensor and remove it from the computer.
Installing the Thermal Sensor
NOTE: The Thermal Sensor is an optional component and your computer may not ship with it.
1. Replace the thermal sensor in its slot and tighten the latch securing it to the computer.
2. Install the cover.
3. Follow the procedures in After Working Inside Your Computer.
Removing the Hard Drive
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the cover.
3. Remove the hard-drive power supply cable and the hard-drive data cable from the hard drive.
12
To Next Page
Loading...
