Installing the System Board
1. Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
2. Tighten the screws to secure the system board to the chassis.
3. Connect the cables to the system board.
4. Install the following components:
a) processor
b) heat sink
c) heat-sink fan
d) air tunnel
e) thermal sensor
f) memory module(s)
g) PCI card
h) coin-cell battery
i) cover
5. Follow the procedures in After Working Inside Your Computer.
System Board Components
The following image displays the system board components.
34
To Next Page
Loading...
