support.dell.com System Memory Upgrade 1-7
! "#" $
If a RIMM is already installed in the socket you want to use, you must remove it. For
instructions, see “Removing a RIMM” on page 1-8.
To install a RIMM, perform the following steps (see Figure 1-2).
1. Locate the plastic securing clips at each end of the socket. Press the clips out-
ward until they snap open.
&++
' $('%+$+$
+
$ $$
$(
2. Press the RIMM straight into the socket until the securing tabs snap into place
around the ends of the RIMM.
securing
notches (2)
clips (2)
To Next Page
Loading...
