Dell S2318Nc - Power Save Mode and No Signal Messages

Operating Your Monitor | 31
When the monitor enters the Power Save Mode, the following message appears:
Dell S2318HN/NX
Entering Power Save Mode.
If you press any button other than the power button, the following messages will
appear depending on the selected input:
Dell S2318HN/NX
There is no signal coming from your computer. Press any key on the
keyboard or move the mouse to wake it up. If there is no display, press
the monitor button now to select the correct input source on the
On-Screen-Display menu.
If VGA or HDMI cable is not connected, a floating dialog box as shown below appears.
The monitor will enter Power Save Mode after 4 minutes if left at this state.
Dell S2318HN/NX
No VGA Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
Dell S2318HN/NX
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
No HDMI Cable
?
See Troubleshooting for more information.