Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the memory module and provide a visual representation of the installation
procedure.
Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module firmly into the memory-module slot at an angle.
3. Press down on the memory module to snap it on the system board. Ensure that the memory-module retention clips have
locked the memory module.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
4. Repeat steps 1, 2 and 3 to install the second memory module, if applicable.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
M.2 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
Removing and installing Customer Replaceable Units (CRUs)
43
To Next Page
Loading...
