shipped with your computer.
This procedure assumes that you have completed the removal procedure Removing the Optical Drive.
1. Connect the optical drive cable to the connector on the system board.
2. Replace the M2.5 x 5-mm screw to secure the optical drive to the system board.
3. Replace the palm rest (see Replacing the Palm Rest
).
4. Replace the display assembly (see Replacing the Display Assembly
).
5. Replace the keyboard (see Replacing the Keyboard
).
6. Replace the hinge cover (see Replacing the Hinge Cover
).
7. Replace the WLAN card (see Replacing a WLAN Card
).
8. Replace the hard drive cover. See Removing the Hard Drive
for an illustration of the hard drive cover.
Back to Contents Page
To Next Page
Loading...
