Installing the Heat-Sink Assembly
1. Align the captive screws on the heat-sink assembly with the screw holes on the system board.
2. Tighten the captive screws to secure heat-sink assembly to the system board.
3. Connect the fan cable to the system board.
4. Install:
a) fan shroud.
b) cover.
5. Follow the procedures in
After Working Inside Your Computer
.
Removing the Input/Output (I/O) Panel
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) cover
b) fan shroud
c) front bezel
d) drive cage
e) expansion card
3. Disconnect the I/O panel cables from the system board
17
To Next Page
Loading...
