Dell Vostro 320 - Memory Module

Back to Contents Page
Memory Module
Dell™Vostro™320ServiceManual
Removing the Memory Module
NOTE: You may need to install Adobe®Flash®Player from Adobe.com to view the following illustrations.
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the front bezel panel.
3. Remove the internal panel.
4. Remove the I/O cover.
5. Remove the hinged stand.
6. Remove the optical drive.
7. Remove the back cover.
8. Remove the back metal-shield.
9. Remove the system-board shield.
10. Push down on the memory retention clips to release the memory module.
11. Remove the memory module from its slot on the system board and place it on a clean, dry surface.
Replacing the Memory Module
To replace the memory module, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.