Steps
1. Adhere the magnet and the metal bar to the battery.
NOTE: Install the magnet and the metal bar from the faulty battery.
2. Align the screw holes on the battery with the screw holes on the system board and palm-rest assembly.
3. Replace the two screws (M1.2x4) that secure the battery to the system board.
4. Replace the seven screws (M1.6x3) that secure the battery to the palm-rest assembly.
5. Place the interposer board to the connector on the system board.
NOTE: The interposer board is not polarity sensitive and both sides are compatible.
6. Connect the battery cable to the interposer board.
7. Replace the Torx 5 screw (M1.6x3.4) that secures the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following images indicate the location of display assembly and provide a visual representation of the removal procedure.
16
Removing and installing components
To Next Page
Loading...
