Table 5. System setup options—Integrated Devices menu (continued)
Integrated Devices
Enable Thunderbolt (and PCIe behind TBT)
pre-boot modules
Enables or disables to allow or disallow PCIe devices to be connected through a
Thunderbolt adapter during pre-boot.
Default: OFF
Miscellaneous Devices
Enable Fingerprint Reader Device Enables or disables the Fingerprint Reader Device.
By default, Enable Fingerprint Reader Device is selected.
Enable Fingerprint Reader Single Sign On Enables or disables the Fingerprint Reader Device's Single Sign On capability.
By default, Enable Fingerprint Reader Device's Single Sign On capability is
selected.
Table 6. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Configures operating mode of the integrated SATA hard drive controller.
Default: AHCI/NVMe. Storage device is configured for AHCI/NVMe mode.
Storage Interface Displays the information of various onboard drives.
Port Enablement Enables or disables the M.2 PCIe SSD.
Default: ON
Drive Information Displays the information of onboard drives.
Enable MediaCard Enables to switch all media cards On/Off or set the media card to read-only
state.
By default, Enable Secure Digital (SD) Card is selected.
Table 7. System setup options—Display menu
Display
Display Brightness
Brightness on battery power Sets the screen brightness when the computer is running on battery power.
Default: 50
Brightness on AC power Sets the screen brightness when the computer is running on AC power.
Default: 100
Touchscreen
Touchscreen Enables or disables the touchscreen.
Default: ON
Full Screen Logo
Full Screen Logo Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
System setup 49
To Next Page
Loading...
