NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. Make the appropriate changes again after you replace the system board. After your computer is reassembled
and powered on, it prompts for the Real Time Clock (RTC) reset. When the RTC reset cycle occurs, the computer
restarts several times and then an error message is displayed- "Time of day not set". Enter the BIOS when this error
appears and set the date and time on your computer to resume normal functionality.
About this task
The following image indicates the connectors on your system board.
Figure 2. System-board connectors
1. Fingerprint reader-board cable
2. Antenna cables
3. Keyboard control-board cable
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
42
Removing and installing components
To Next Page
Loading...
