To Next PageTo Next PageWhy DeLonghi Artic Whisper PAC EM375WRC doesn't cool the room?
Your DeLonghi Air Conditioner might not be cooling the room because doors, windows, or curtains are open. Make sure to close them. Also, eliminate any heat sources in the room, such as an oven. Ensure the air exhaust hose is correctly fitted to the housing at the back of the appliance. Finally, a clogged filter can also cause this issue, so clean or replace the filter.
What to do if 'HL' frequently appears on DeLonghi Artic Whisper PAC EM375WRC display?
If “HL” frequently appears on the display of your DeLonghi Air Conditioner, it indicates high ambient humidity. Attach the provided hose (B5) to the upper drainage hose (A10) to allow water to flow into a container, being careful to prevent overflows.
What to do if my DeLonghi Air Conditioner does not come on?
If your DeLonghi Air Conditioner doesn't turn on, first ensure it's properly plugged into the outlet. Check if there's a power outage and wait for the power to be restored. Also, the LCDI plug on the power cord might be tripped; push the reset button on the LCDI plug.
Why does my DeLonghi Artic Whisper PAC EM375WRC work for a short time only?
If your DeLonghi Air Conditioner operates only briefly, it may be due to bends or kinks in the air exhaust hose. Position the air hose correctly, keeping it as short and free of curves as possible to avoid bottlenecks. Also, check for and remove any obstacles obstructing air discharge.
Why DeLonghi Artic Whisper PAC EM375WRC Air Conditioner does not operate immediately after restarting?
If your DeLonghi Air Conditioner doesn't restart immediately, it's because an internal safety device prevents restarting for approximately three to four minutes after being turned off. Wait about three minutes and try again. This delay is normal.
What to do if there is no display showing in my DeLonghi Artic Whisper PAC EM375WRC remote control?
If there's no display on your DeLonghi Air Conditioner remote control, the batteries are likely exhausted. Replace them.
Why does my DeLonghi Artic Whisper PAC EM375WRC Air Conditioner smell?
An unpleasant smell from your DeLonghi Air Conditioner during operation is often due to a clogged filter. Clean the filter as described in the manual.
What to do if there are two dashes appearing on DeLonghi Artic Whisper PAC EM375WRC Air Conditioner remote control but it is not working?
If two dashes appear on your DeLonghi Air Conditioner remote control and it's not working, the remote is probably not turned on. Press the ON/OFF key on the remote control.
General| Type | Portable Air Conditioner |
|---|---|
| Energy Efficiency Ratio (EER) | 11.2 |
| Refrigerant | R290 |
| Power Consumption | 1120 W |
| Features | Remote control, 24-hour timer, 3 fan speeds, Remote control |
Details the electrical specifications of the portable air conditioner, including voltage and frequency.
Specifies the intended domestic use of the appliance and warns against improper or hazardous applications.
Provides essential instructions for correctly installing the appliance in compliance with national standards.
General advice to read instructions carefully before use to prevent damage or injury.
Important pre-operation checks including packaging material and appliance completeness.
Guidance on verifying the appliance's completeness and condition after unpacking.
Instructions to ensure drain plugs are properly attached to prevent water leakage.
Lists and identifies the various parts and components of the portable air conditioner.
Details the different accessories provided with the air conditioner for its operation.
Step-by-step guide for installing the window kit for a double-hung window.
Provides a detailed explanation of each button and indicator on the appliance's control panel.
Instructions on how to power the air conditioner on and off using the control panel.
Details on setting the air conditioner for cooling and dehumidifying in hot, humid weather.
Explains how to activate a function to further reduce the appliance's noise level.
Describes a technology that regulates temperature and humidity for optimal comfort.
Instructions for using the appliance to reduce room humidity, especially in damp conditions.
Guidance on operating the appliance solely as a fan for air circulation.
How to switch the temperature display between Celsius (°C) and Fahrenheit (°F).
Instructions on programming delayed start-up or shut-down for energy optimization.
Steps for inserting or replacing batteries in the remote control unit.
How to operate the air conditioner using the ON/STAND-BY button on the remote control.
Details on how to choose different operating modes using the remote control's MODE button.
Instructions for adjusting the desired temperature using the remote control's increase/decrease buttons.
How to adjust the fan speed (minimum, medium, maximum, auto) via the remote control.
Procedure to change the temperature unit display between Celsius and Fahrenheit using the remote.
How to program delayed shut-down or start-up using the remote control's timer function.
Explains common error codes (LE, PF, HL) displayed by the appliance and troubleshooting steps.
Instructions for cleaning the exterior cabinet of the air conditioner safely and effectively.
Guidance on how to clean the air filter to maintain the appliance's efficiency.
Specifies the acceptable room temperature range for air conditioning operation.
Important warnings regarding transporting the unit to avoid damage and ensure compressor oil return.
Troubleshooting steps for when the air conditioner does not power on.
Diagnosing issues causing the air conditioner to work only for a short period.
Solutions for when the air conditioner is running but not cooling the room effectively.
Steps to address unpleasant smells during operation, often related to filter issues.
Explanation for the delay before restarting the appliance after it has been turned off.
Troubleshooting the 'HL' display, often related to high ambient humidity or drainage.
Guidance for interpreting error codes (Lt/PF/HL) shown on the display.
Troubleshooting steps for when the remote control is not displaying or functioning.
