8
DESCRIPTION OF APPLIANCE
A) Filter Acces Door
B) Filter Change Indicator
C) Filter Cartridge
D) Odour-preventing activated carbon filter
E) Washable prefilter
F) HEPA Filter Media
INSTRUCTIONS FOR USE
1.Unpack the air purifier and place it either vertically (upright), horizontally, or wall-
mounted in such a way that the air intake grill and air outlet are free from
obstructions. An ideal position is near a wall in a central location.
Wall mounting
Your unit can be wall mounted.
Use a drill to make two holes 19.2 cm apart (26.5 cm DAP 130) (fig. 4). Insert the
pressure screws into the holes then hang the unit.
2.After checking that the voltage of your home corresponds to that indicated on the
appliance, plug it in to the power point;
3.Set the desired operating speed with the selector M; the pilot light will come on;
4.To release negative ions into the air through the purifier, switch on the ionizer; the
pilot light will come on;
5.To reach the best level of air filtration, continuous use of the purifier is recommended.
Its sturdy motor has been designed to guarantee many years of operation.
For continual use, you are recommended not to run the fan at maximum speed.
For lower noise levels or in the bedroom, select SLEEP mode.
If there are large quantities of impurities in the room, select the highest position
for faster air circulation and filtering.
CLEANING THE APPLIANCE
Clean the outside of the air purifier with a soft, clean, damp cloth to remove dust,
grime and fingerprints.
The prefilter E can be removed (fig. 3) and washed separately in warm, soapy water
(NOT in a dishwasher). Dry the components carefully before replacing.
WARNING: Do not use water to clean the purifier.
G) Air intake grille
H) Ionizer Indicator light
I) Ion switch
L) Purifier Indicator light
M) Speed Control
N) Air outlet grille
To Next Page
Loading...
