DeLonghi DE609MP - Page 24

PROGRAMMER
MESSAGE
MESSAGE MEANING
WHAT TO DO
variable
Cooking time set or oven tempe-
rature measured by the internal
sensor.
To change the cooking temperatu-
re press key 4 of the programmer,
then keys 5 or 6.
A temperature below 50°C has
been set.
The oven has switched off.
Press key 4 of the programmer,
then keys 5 or 6.
The audible signal has switched
off after the end of cooking (End).
Turn the function selector knob to
0. The time will appear.
dEF = defrost
The “defrosting frozen food” fun-
ction has been set.
To turn the oven off turn the fun-
ction selector knob to
0.
I
I
I
I
I
I
I
I
I
I
I
End with AUTO ashing and au-
dible signal.
End of the programmed cooking.
Press any programmer key to si-
lence the audible signal
OFF ap-
pears (see specic note).
Turn the function selector knob to
0.
I
I
I
I
I
I
I
00.00 with bell symbol ashing
and audible signal. End of the ti-
mer countdown.
Press any programmer key to si-
lence the audible signal.
The time appears.
Start of the Pyrolysis cycle.
To increase the cycle length, up to
max 3 hours, press key 2 of the
programmer then key 6. To redu-
ce to the minimum 1 hour 30 mi-
nutes press key 2 of the program-
mer and then key 5.
I
I
I
I
I
I
I
I
I I
I
I
I
I
I
I
P0.00 with P ashing.
This appears after do.Lo, becau-
se the function selector knob has
been moved from the Pyrolysis
function to a cooking function. The
temperature has dropped below
300°C. The key LED goes out and
the door unlocks.
Turn the oven selector knob to
0
and repeat the operations to start
the Pyrolysis cycle.
P0.00 with P ashing. The oven
selector knob has been moved to
the Pyrolysis function (P).
To start the Pyrolysis cycle press
key 3 of the programmer.
To cancel the operation turn the
oven function selector knob to
0.
I
I
I
I
I
I
I
I
I
I
I
P0.00 with AUTO ashing. End
of the pyrolysis cycle. This messa-
ge remains until the door unlocks.
Wait for the door to unlock.