19
24. EXPLANATION OF LIGHTS
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING
Insucient water in the tank (A17) Fill the tank with water and/or insert it correctly,
pushing it as far as it will go until it clicks into
place.
ON STEADILY
The tank (A17) is missing or not correctly
in place
Insert the tank correctly, pushing it as far as it
will go until it clicks into place.
FLASHING
The grounds container (A11) is full
Empty the grounds container and drip tray (A15),
clean and replace (g. 16). Important: when re-
moving the drip tray, the grounds container must
be emptied, even if it contains few grounds. If this
is not done, when you make the next coees, the
grounds container may ll up more than expected
and clog the machine.
ON
After cleaning, the grounds container
(A11) has not been replaced
Remove the drip tray (A15) and insert the
grounds container.
ON STEADILY
FLASHING
The coee beans have run out Fill the beans container (A3 -
g. 9
).
The pre-ground coee funnel (A4) is
clogged
Empty the funnel with the help of the brush (C5)
as described in section “18.8 Cleaning the pre-
ground coee funnel”.
ON STEADILY
FLASHING
The pre-ground coee function has been
selected without placing any pre-ground
coee in the funnel (A4)
Place pre-ground coee in the funnel (
g. 12
) or
deselect the "pre-ground" function.
The pre-ground coee funnel (A4) is
clogged
Empty the funnel with the help of the brush (C5)
as described in section “18.8 Cleaning the pre-
ground coee funnel”.
FLASHING
The machine must be descaled The descaling procedure described in section
“19. Descaling” needs to be performed.
To Next Page
Loading...
Need help?
General
