Description
N.B.:
Keep these instructions. If the appliance is passed to other per-
sons, they must also be provided with these instructions.
DESIGNATED USE
• This appliance must be used exclusively for the purpose
for which it was expressly conceived.
Any other use is considered improper and thus dange-
rous.
• The manufacturer is not liable for damage caused by inap-
propriate, incorrect or irresponsible use or for damage re-
sulting from repairs carried out by unqualied personnel.
Important!
The machine works with normal tap water.
Incaseofveryhardwater(hardnessabove27°f)wesuggest
using demineralised water diluted with 50% tap water.
The resin lter installed in the tank lters impurities,
and keeps the plate clean, thus ensuring constant ste-
am delivery during ironing.
Never use chemical substances or detergents (e.g.
perfumed water, essences, descaling solutions, etc).
Do not use mineral water.
Important!
If you use ltering devices, make sure the water obtained has
a neutral pH.
Using the appliance for the rst time
• Thersttimeyouusetheiron,removetheplateprotec-
tion(ifpresent).
• When used for the rst time, the appliance may
give o smoke and an odour for several minutes.
This is caused by heating and subsequent drying of
the sealers used in assembling the appliance.
You are recommended to ventilate the room.
Ironing tips
• Theoriginalappearanceand softnessoffabrics suchas
velvet or wool, or gloves, bags etc. can be restored by pas-
sing the iron a short distance away with the steam jet in
operation.
• Donotrestorusetheirononzips,hooks,ringsetctoavoid
scratching the sole plate.
• Separateclothesaccordingtotherecommendedironing
temperature and begin ironing with items requiring the
lowest temperatures.
• Silkmaybedry-pressedonthereverse.
• Wool,cottonandnelinencaneitherbesteam-ironedon
the reverse or on the right side, interposing a thin cloth
between the iron and the fabric to avoid “shine”.
• Starchedfabricsrequiregreatermoisture.
• Ironwhitesandlightcoloursontherightsideanddark
colours on the reverse. Embroidery should also be ironed
on the reverse to make it stand out.
To obtain a good steam jet, wait a few seconds between
one burst of steam and the next.
The no-drip system automatically shuts o steam pro-
duction when the temperature is set too low to prevent
the plate from dripping.
Description
A. Power cable
B. Auto-olight(AUTOSHUTOFF)(*certainmodelsonly)
C. Rubber vertical iron rest
D. ON/OFF light
E. Spray button
F. Steam regulator:
pos. : no steam
pos. 1: min. steam
pos. 2: max. steam
G. “EasyTurbo”button(steamburst)
H. “Self Clean” button
I. Tank ll hole cap
J. Spray
K. Thermostat dial
L. Water measure
en