DeLonghi EC685 - Page 27

27
The coee froth is too dark
(delivered from the spout too
slowly)
The pre-ground coee is pressed down
too firml
Press the coee down less firml
There is not enough pre-ground coee Reduce the quantity of pre-ground coee
The espresso boiler outlet is blocked Clean as described in section “11.4 Cleaning the
boiler outlet”
The fil er or the perforated fil er is
blocked
Clean as described in section “11.3 Cleaning the
coee fil ers”
The pre-ground coee is too fin Use only pre-ground coee for espresso coee
makers
The pre-ground coee is too fine or damp Use pre-ground coee for espresso coee makers
only and make sure it is not too damp
Limescale in the water circuit Descale as described in section “11.7 Descale”
After delivering coee, the fil er
remains attached to the boiler
outlet
Insert the fil er holder again, deliver coee, then
remove the fil er holder
The appliance will not make
any drink and the
,
and lights flash for a few
seconds
No water in the tank Fill the tank with water
The tank has been inserted incorrectly
and the valves on the bottom are not
open
Press the tank down lightly to open the valves on
the bottom
The espresso boiler outlet is blocked Clean as described in section “11.4 Cleaning the
boiler outlet”
The fil er is blocked Clean as described in section “11.3 Cleaning the
coee fil ers”
Limescale in the water circuit Descale as described in section “11.7 Descale”
The appliance does not func-
tion and all the lights flas
Disconnect the appliance immediately and contact
authorised Customer Services.
No milk froth is formed when
making cappuccino
The ring is in the “HOT MILK” position Push the ring into the “CAPPUCCINO” position.
Milk not cold enough Always use milk at refrigerator temperature
Cappuccino maker dirty Clean as described in section “8. Cleaning the cap-
puccino maker after use”
Limescale in the water circuit Descale as described in section “11.7 Descale”
At the end of descaling, the ap-
pliance requests a further rinse
During the rinse cycle, the water tank has
not been filled o the MAX level
Repeat the rinse cycle from point 10 of the section
"Explanation of lights" “11.7 Descale”