12
2. Place a cup or other container under the milk spout tube.
3. Keep the “CLEAN” button (g. 25) pressed: lights
and
ash. When the lights stop ashing and the
appliance goes back to ready for use, release the “CLEAN”
button: the steam cleans the circuits inside the milk
frother.
Program the amount of coee and milk in the cup for
cappuccino or milk
The machine has been set by default to deliver standard amounts
of coee and milk. If you would like to amend these quantities,
proceed as follows:
1. Place a cup under the coee spouts and the milk spout
tube.
2. Press the button relative to the preparation with milk to
be programmed and keep it pressed. After a few seconds,
the machine starts delivering the milk.
3. Once the required quantity of milk has been delivered into
the cup, release the button; milk delivery stops.
4. Program the amount of coee into the cup as for the
amount of milk.
5. Programming is conrmed by the lights ashing for 3
seconds.
The machine is now re-programmed according to the new
amounts of milk and coee.
Preparing the hot water and steam
Scalding hazard!
Do not leave the machine unattended when delivering hot
water. The spout heats up during delivery, therefore, only the
black part must be held.
Delivering hot water
1. Check the hot water spout is correctly attached (g. 8).
2. Place a cup under the spout (as near as possible to avoid
sprays).
3. Press the button (B7): the relative light ashes and
the appliance starts hot water delivery.
4. The machine automatically stops delivery.
Please note!
• To manually interrupt the hot water delivery, press
button again.
Programming the amount of water automatically
delivered
If you would like to amend the amount of water set by default,
proceed as follows:
1. Place a cup under the water spout.
2. Keep the button pressed.
3. When the hot water in the cup reaches the required level,
release the button. Programming is conrmed by the
lights ashing for three seconds.
The machine is now re-programmed according to the new
amount.
Delivering steam
1. Check the hot water spout is correctly attached (g. 8).
2. Fill a container with the liquid to be heated/frothed and
immerse the water/steam spout into the liquid.
3. Press twice the button (B7): the relative light ashes
and the appliance starts steam delivery.
4. When the required temperature is obtained, interrupt
steam delivery by pressing the button again. (You should
not discharge steam for more than 3 minutes at a time).
Important!
Always stop steam delivery before extracting the container
containing the liquid to avoid burns from splashes.
Cleaning the water spout after use
Always clean the spout after use to avoid the build-up of milk
residues and prevent the spout from clogging.
1. Place a container under the cappuccino maker and press
the button to deliver a little water (g. 3).
Stop the ow of water by pressing the button
again.
2. Wait a few minutes for the cappuccino maker to cool
down, then extract the hot water spout.
3. Check the hole is not blocked. If necessary, clean with a
pin.
4. Wash all parts of the cappuccino maker thoroughly with a
sponge and warm water.
5. Reinsert the water spout.
Cleaning
Attention!
• Do not use solvents, abrasive detergents or alcohol to
clean the machine.
• Only the milk container (D) can be washed in the dish
washer. No other part of the appliance can be washed in
the dishwasher.
•
Do not use metal objects to remove coee deposits or
fouling as they might scratch the metal or plastic surfaces.
en
Instructions for use
To Next Page
Loading...
Need help?
General
