13
7. Remove the milk container and always clean the steam
connection nozzle with a sponge (see g. 22).
Please note!
• To prepare a number of milk based coees, clean the milk
container after you have prepared the last drink only.
• The milk container can be kept in the refrigerator.
DELIVERING HOT WATER
Important! Danger of burns.
Never leave the machine unsupervised while delivering hot
water or steam.
The spout becomes hot during delivery. Hold by the handle only.
Delivering hot water
1. Make sure the hot water spout is attached correctly (g. 2).
2. Place a container under the spout (as close as possible to
avoid splashes).
3. Turn the selection knob (g. 9) until the
light comes
on.
4. If you want to deliver a double size, press the
button:
the corresponding light comes on.
5. Press the
button.
6. The machine delivers hot water, then stops automatically.
To interrupt delivery of hot water manually, press the
button again.
CLEANING
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coee maker.
With De’Longhi bean to cup coee makers, you need not
use chemical products to clean the machine.
• None of the components can be washed in a dishwasher
apart from the milk container (D).
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
Cleaning the coee grounds container
When comes on, the grounds container must be emptied
and cleaned.
Until the grounds container has been cleaned, the appliance
continues to display the message and coee cannot be made.
Important! Danger of burns
If you make a number of cappuccinos one after the other, the
metal cup tray becomes hot.
Wait for it to cool down before touching it and handle it from
the front only.
To clean (with the machine on):
• Remove the drip tray (g. 23), empty and clean.
• Empty the grounds container and clean thoroughly to re-
move all residues left on the bottom. This can be done with
the spatula on the brush provided.
• Check the condensate tray (red) and empty if necessary.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the grounds
container may ll up more than expected and clog the machine.
Cleaning the drip tray and condensate tray
Important!
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 24).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned, otherwise the water may over-
ow the edge and damage the appliance, the surface it rests on
or the surrounding area.
To remove the drip tray:
1. Remove the drip tray and the grounds container (g. 23);
2. Empty the drip tray and grounds container and wash them;
3. Check the red condensate tray and empty if necessary.
4. Replace the drip tray and grounds container.
Cleaning the inside of the coee maker
Danger of electric shock!
Before cleaning internal parts, the machine must be turned
o (see “Turning o”) and unplugged from the mains power
supply.
Never immerse the coee maker in water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coee deposits with the brush
provided or a sponge.
2. Remove the residues with a vacuum cleaner (g. 25).
Cleaning the water tank
1. Clean the water tank (A11) regularly (about once a month
and whenever you replace the water softener lter (if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank.