EasyManuals Logo

DeLonghi ELETTA CAPPUCCINO EVO ECAM46.86X User Manual

DeLonghi ELETTA CAPPUCCINO EVO ECAM46.86X
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
Replace lter
ESC to cancel
OK to replace
The water softener lter (C4) is exhausted. Replace the lter or remove it as described in
section "14. Water softener lter".
General alarm The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section "11. Cleaning". If the
message is still displayed after cleaning, con-
tact a customer service centre.
The tubes inside the milk container (D) must
be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 17)
.
The water softener lter (C4) is exhausted and
must be replaced or removed.
Replace the lter or remove it as described in
section "14. Water softener lter".
The machine must be descaled. The descaling procedure described in section
"12. Descale" needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
ECO
Energy saving is enabled. To disable energy saving, proceed as described
in section "6.4 General" - "Energy saving:"
18. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact customer services.
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coee was made.
Before making coee, heat the infuser by
performing a rinse cycle (see section "6.1
Rinsing").
A low coee temperature is set. Set a higher coee temperature in the menu
(see section "6.4 General""Set temperature:")
The coee is weak or not
creamy enough.
The coee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (g. 11). Continue one
click at a time until coee delivery is satisfac-
tory. The eect is only visible after delivering
2 coees (see section "7.4 Adjusting the coee
mill").
The coee is unsuitable. Use coee for espresso machines.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeLonghi ELETTA CAPPUCCINO EVO ECAM46.86X and is the answer not in the manual?

DeLonghi ELETTA CAPPUCCINO EVO ECAM46.86X Specifications

General IconGeneral
BrandDeLonghi
ModelELETTA CAPPUCCINO EVO ECAM46.86X
CategoryCoffee Maker
LanguageEnglish

Related product manuals