DeLonghi ESAM4500 - Page 9

10
MENU SETTINGS
The following menu items can be selected: Clock, Start, Auto-
start, Descale, Temperature, O after, Water hardness, Default
values.
To access the settings menu, press the MENU button. The light
on the button comes on.
Clock
To adjust the time on the display, proceed as follows:
1. Access the menu and press the NEXT button until “CLOCK”
is displayed;
2. Press the CHANGE button to change the time (hold the
button down to change the time rapidly). When you have
nished, release the button. The time ashes.
3. Press the OK button to conrm;
4. Press the MENU button to exit the menu. The light on the
button goes o.
The time displayed when the machine is o (stand-by) is now
set.
Turning on
Once “AUTO-START Yes” has been enabled, the auto-start time
must be set as follows:
1. Access the menu and press the NEXT button until “START”
is displayed.
2. Press the CHANGE button to change the start time (hold
the button down to change the time rapidly). When you
have nished, release the button. The auto-start time
ashes on the display.
3. Press the OK button to conrm.
4. To exit the menu, press the MENU button. The light on the
button goes out.
The auto-start time has been programmed.
Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coee immediately.
Please note!
To enable this function, the time must be set correctly (see
previous section “Clock”).
To set the auto-start time, proceed as described in the section
below.
1. Access the menu and press the NEXT button until “AUTO-
START No” or “AUTO-START Yes” (if the function has been
enabled) is displayed;
2. Press the CHANGE button to change the selection. The
new selection ashes on the display;
3. Press the OK button to conrm;
To set the auto-start time, proceed as described in the section
below.
The symbol is displayed alongside the clock to indicate
that auto-start has been programmed (in stand-by).
Descaling
For instructions on descaling, see page 15
Temperature
To modify the temperature of the water used to make the
coee, proceed as follows:
1. Access the menu and press the NEXT button until
“TEMPERATURE” is displayed;
2. Press the CHANGE button until the required temperature
(low, medium, high, maximum) is displayed;
3. Press the OK button to conrm;
4. Press the MENU button to exit the menu. The light on the
button goes o.
O after (Stand-by)
The appliance is set by default to go o if not used for two
hours.
The time can be changed so that the appliance switches o
after 15 or 30 minutes, or after 1, 2 or 3 hours.
1. Access the menu and press the NEXT button until “OFF
AFTER” is displayed;
2. Press the CHANGE button to select the required period of
time;
3. Press the OK button to conrm;
4. Press the MENU button to exit the menu. The light on the
button goes o.
Auto-o is programmed.
Water hardness
For instructions on setting water hardness, see page 15.
Default values (reset)
This resets all menu settings and programmed quantities back
to the default values (with the exception of the language
which remains as set).
1. Access the menu and press the NEXT button until
“DEFAULT VALUES No” is displayed;
2. Press the CHANGE button to change the selection to
“DEFAULT VALUES Yes”. The new selection ashes on the
display;
3. Press the OK button to restore the original settings.
Setting the language
For instructions on setting the language, see page 16.