8
en
cleaning and maintenance
Fault Cause Solution
Unpleasant smells The anti-odour lter (B) is saturated
The oil has deteriorated.
The cooking liquid is unsuitable.
Replace the lter
Replace the oil or fat.
Use good quality peanut oil
Oil overows The oil has deteriorated and produces too much
foam
You have immersed food which is not suciently
dry in the hot oil
Basket immersed too rapidly.
The oil level in the deep fryer is over the maxi-
mum limit
Replace the oil or fat
Dry the food well.
Immerse slowly.
Reduce the amount of oil in the fryer bowl.
The oil does not
heat up
The thermal cutout may have tripped Contact the manufacturer’s customer services (the device
must be replaced).
Only half the basket
is fried correctly
The basket is not rotating during cooking. Clean the bottom of the bowl.
Clean the basket wheel ring thoroughly (g. 19).
REPLACING THE ANTI-ODOUR FILTER
With time, the anti-odour lter inside the lid loses its eciency.
To replace, remove the plastic lter cover (A) (g. 11).
Anti-odour lters can be obtained from authorised dealers or the
manufacturer’s customer services.
CLEANING
Danger! Always unplug from the mains socket before cle-
aning.
Never immerse the deep fryer in water and never place it under
running tap water.
If water gets into the appliance, it could cause electric shock.
Please note: After leaving to cool down for about two
hours, empty the oil or fat as described in the paragraph “ltering
the oil or fat”.
Never empty the fryer by tipping or overturning it (g. 17).
Wash the bowl, basket and lid (remove lter) in hot water and
washing up liquid.
To remove the lid (Z), push backwards and at the same time pull
upwards (see arrows “A” and “B”, g. 18).
Important! Never immerse the lid in water without remo-
ving the lter rst.
To clean the bowl (D), proceed as follows:
• Extract the bowl from the fryer by lifting it gently (see gure
8) and wash with hot water and washing up liquid using a
soft sponge.
• The bowl and basket are dishwasher safe.
Be careful not to knock the hose as this could jeopardise cor-
rect operation.
• To replace the bowl, open the drainage hose compartment
door (R), then insert the bowl at an angle with the drainage
hose in the horizontal position and cap in place. Then close
the door.
• If the oil lter (C) in the bowl is dirty or clogged, turn anti-
clockwise, remove and clean.
Important! To avoid damaging the non-stick surface of the
bowl, never use abrasive objects or detergents to clean the bowl.
Clean with a soft cloth and neutral detergent only.
TROUBLESHOOTING
To Previous Page
Loading...
