4
to avoid obstruction to the air intake grille located under it.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet can
be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in
area.
- A tip over safety device turns the appliance o if it falls over
or is positioned inappropriately in such a way as to jeopar-
dise safety.
The appliance emits a beep and a dot ashes on the display.
The appliance resumes operation a few seconds after being
placed in an upright position again.
See troubleshooting
session.
- The appliance is tted with a safety device which will
switch the appliance o in case of accidental overheating.
To reset, disconnect the plug from the power socket for a
few minutes, remove the cause of overheating then plug
the appliance in again.
If this abnormal situation happens several times, please
contact De'Longhi Customer Experience.
Danger of burns!!
- To avoid risk of cable overheating, extension leads must not
be used in powering this appliance.
The appliance complies with the following EC directives:
- Low Voltage Directive 2006/95/EC and subsequent
amendments;
- EEC Directive 2004/108 on electromagnetic compatibility
(EMC) and subsequent amendments;
Use in compliance with intended use
Use this heater only as described in this manual. All other use is
considered improper. This appliance is not suitable for
commercial use.
The manufacturer is not liable for damage deriving from
improper use of the appliance. This is a household appliance
only. It is not intended to be used in:
• staff kitchen areas in shops, offices and other working
environments;
• farm houses;
• by clients in hotels, motels and other residential type
environments;
• bed and breakfast type environments.
Use in this manner will invalidate the manufacturers warranty.
Disposing of the appliance
In compliance with European directive 2002/96/EC, the
appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.
INTRODUCTION
Read these instructions carefully before using the appliance.
Failure to comply with these instructions can lead to injury to
persons and damage to the machine.
The manufacturer is not liable for damage deriving from the
failure to comply with the user instructions.
Symbols used in these instructions
Important warnings are identied by the symbols below.
It is important to respect the warnings.
Failure to respect the warnings could lead to electric shock,
serious injury, burns, re or damage to the appliance.
Important!
Failure to observe the warning could result in injury or damage
to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
Fundamental recommendations regarding safety
Dear Customer – The plug on this appliance will get ‘warm’
during use, this is perfectly normal. This product is A HIGH
POWER HEATING APPLIANCE designed to our usual high
standards but please make sure your wall sockets are in good
condition and the plug is inserted correctly to avoid any
accidental overheating. We suggest that you check the plug
AND THE SOCKET regularly if the heater is in prolonged use, if
you are in any doubt please consult an electrician.
General instructions
Remove the heater from the packaging. Check that neither the
heater nor the power cable has been damaged during transport.
Do not operate the heater if damaged. Remove all publicity
material present on the appliance. The appliance is suitable for
free-standing or wall-mounted usage. Do not assemble the feet
if wall-mounted.
To Next Page
Loading...
Need help?
General