6
TM
1. Plug into the mains.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector to
the position.
4. Low power operation: turn the function selector to po-
sition 1.
5. Max power operation: turn the function selector to po-
sition 2.
6. Switching o: turn the function selector to the “0” posi-
tion.
Setting the thermostat
Position the thermostat on maximum.
When the room has reached the required temperature, turn
the thermostat dial slowly anticlockwise until you hear a click
and the fan goes o. The thermostat will then keep room
temperature at the selected level automatically.
Frost prevention mode
With the function selector in position 2 and the thermostat
dial in position , the appliance maintains room tempera-
ture at about 5°C, preventing freezing with minimal energy
consumption.
Models with thermostat only
To switch the appliance on turn the thermostat dial as far as
it will go to maximum position. To set refer to the paragraph
“Setting the thermostat”. To turn the appliance o comple-
tely, turn the dial anticlockwise to minimum, then unplug
from the mains socket.
MODELS WITH SWITCH
- Heating at low power: press switch (the red zone can
be seen on the switch).
- Heating at maximum power: press both switches ;
(the red zone can be seen on the switch).
- Turning o: turn o both switches.
We recommend unplugging the power cord when the ap-
pliance is not in use.
Please note: the maximum power is only active when
the switch is pressed.
MODELS WITH SWIVELLING BASE ON/OFF PEDAL
SWITCH
A number of models have a swivelling base and ON/OFF pedal
switch.
The appliance can be manually oriented to an angle of 30°
to the right or left to direct the air ow in the preferred di-
rection.
To turn the appliance on, set the thermostat dial and function
selector as described above, then press the pedal on the base.
To turn the appliance o, just press the pedal again.
Important! the appliance will come on only if you
press the pedal.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the
appliance.
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “