39
The machine doesn’t start and the
lights blinks irregularly.
• Fill the water tank and push buon to start.
• Check that handle is properly locked.
Lights blink while machine is run-
ning.
• If coee or milk is flowing normally, this indicates the machine
is working properly.
• If only water is flowing, the machine is executing a user re-
quest for either cleaning, descaling or emptying the system.
Refer to the corresponding section in this user manual.
Lights blink and machine is not
running.
• It will take some time before the coee flow comes out (due to
code reading and pre-weing the coee).
• Check that a fresh capsule is inserted in correct position, that
the handle is properly locked and push the buon to start.
• Fill the water tank and push buon to start.
• Turn the machine to “OFF mode” by pushing the coee buon
for 3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down aer extensive use.
Lights blink irregularly.
Machine is not running.
• During regular Coee/Espresso preparation: 1) Unlock the
handle and open the machine head to check that a fresh
undamaged capsule is inserted in the correct position.
2) Check that the handle is in “LOCKED” position. 3) Check
that the water tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that cap-
sule is ejected. 2) Check that the handle is in “LOCKED” po-
sition.
• During Programming Volume: 1) Check if a capsule has been
well inserted. 2) Please refer to the corresponding chapter.
• If problem persists:
• 1. Unlock the handle and open machine head.
• 2. Replace capsule (if needed).
• 3. Disconnect powercord from the outlet and plug the ma-
chine back into outlet aer 10 seconds.
• 4. Close the head and press the buon to turn ON and press
again to start brewing. If problem persists, call Nespresso.
Descaling alert blinks or is fixed
orange.
• Machine triggers descaling alert according to your beverage
consumption. Descale the machine. Refer to section “Descal-
ing” according to your beverage consumption.
Rinse alert blinks orange. • A rinsing cycle of the milk carafe is required, refer to section
“Milk Preparation & Daily rinsing”.
I cannot enter the Menu Mode
(Reset to factory seings/ Empty-
ing the system before a period of
non-use/Water hardness seing).
• Be sure to remove the milk carafe from the connector door.
• Be sure that the descaling pipe is not connected to the con-
nector door.
• Press and hold hot foam buon
until descale and rinse
alerts blink.
Turn o the machine.
• Hold the coee buton
for three seconds. See “ Energy
Saving “ section.