8
Preparation for use
HOW TO USE THE AIR CONDITIONER WITH WATER
These air conditioners can use both air and water to cool the condenser (the hot part) of the air
conditioner.
To utilize the full potential of your air conditioner, the tank needs to be filled with water. The
water is used to increase the cooling power and reduce the noise level and energy consumption of the
air conditioner. The water that is used is then expelled from the machine as water vapor through the
exhaust hose (it does not go into room).
Always use clean tap water (which doesn’t contain salts). As a rule the water will usually last about 8
hours, however this depends on the conditions within the room, such as temperature, humidity, insula-
tion and number of people. In cool jet mode the water will also be used more quickly.
25
5
A) To open the front panel
grip the side panel and
gently pull the panel
towards you and upwards.
Remove the tank Lift it
forward.
5
3
B) Turn the tank upside down
and remove the plug.
Remove the extendable
tube and fill the tank, lea-
ving it on the ground.
C) After completing the fil-
ling procedure, replace
the extendable hose and
the cap and screw it in
tightly. Return the tank to
its place, with the writing
FRONT clearly visible.
Carefully hold the panel in
the center and lower to its
closed position.
During the "water functioning" operation and in particularly silent locations (e.g. the bedroom) a
slight gurgling sound may be heard. This is completely normal.
IN HIGH HUMIDITY CONDITIONS
Water is extracted from the air in the room, this water is also used to cool the appliance. When the
humidity is particulary high an excess of water may build up in the internal tank. This can be drai-
ned by removing the stopper from the drain hose and draining into a suitable receptacle.
9
IMPORTANT: If the room temperature is 90°F (32°C) or over the air conditioner must be operated
with water in the tank.
To Next Page
