4
MODEL NO. 182H SWITCH ON REGULATOR (Suitable for Calor Switch-on 21 mm Gas Bottle)
1. Connecting the cylinder
aRotate the plastic cap on the cylinder
valve until the arrow points out through
the gap in the valve shroud.
b Pull the lanyard out, then upwards. The
cap will lift off the valve. Do not use
tools. Leave the cap hanging down from
the valve while the cylinder is in use.
c Ensure that the point of the switch is
pointing down. Place the regulator
down over the cylinder valve.
d Turn the switch clockwise so that it points
to the left (the OFF position). the regula-
tor is now secured gas-tight to the valve,
which is still closed OFF. There will be a
“click” into the lock-on position.
2. Turning the gas on and off
a To turn the gas on, turn the switch clockwi-
se so that it points upwards. The cylinder
valve is now open and the gas is on.
b Turn the switch anti-clockwise to the left
and the gas is off. Do not touch the cen-
tre button.
3. Disconnecting the cylinder
There are 2 steps in disconnecting the regulator
a depress the centre button of the black
switch.
b Keeping the button in the depressed
position, turn the black switch anti-
clockwise until it points downwarnds. The
regulator can be lifted off the valve.
Never turn the switch to the “disconnect” position when the burner is alight. Wait until the bur-
ner and pilot go out; at this point turn the switch to the “disconnect” position.
Always replace the orange safety cap on the cylinder valve.
To Next Page
Loading...
