5
MODEL NO. 541101 REGULATOR
Connecting the cylinder
aTurn the orange cap so that the arrow is
pointing to the gap in the shroud.
b Remove the orange safety cap by pul-
ling the lanyard out, then up. Do not use
tools. Leave the cap hanging.
cCheck that the black sealing washer is
fitted inside the cylinder valve. Place the
regulator down over the valve until the
lever of the coupling engages with an
audible click.
d When gas is required, turn the switch
anticlockwise to the ON (6 o’clock) posi-
tion.
Disconnecting the cylinder
a Turn the switch clockwise to the OFF posi-
tion.
bWAIT until the burner and pilot light have
gone out.
IF THE FLAME DOES NOT GO OUT - TURN
THE SWITCH BACK TO “ON”, LEAVE THE
APPLIANCE ALIGHT, AND CALL YOUR
GAS SUPPLIER.
c Never lift the disconnect lever whilst tur-
ning the ON/OFF switch.
d With the regulator switch in the OFF posi-
tion lift the disconnect lever and lift the
regulator from the cylinder valve.
e REPLACE the orange safety cap onto the
empty cylinder, or part full cylinder if not
in use.
To Next Page
Loading...
