7
HOW TO DEHUMIDIFY
Dehumidifying standby/freeze
protection light
Humidistat dial
Tank full/tank
absent light
How to dehumidify
• Plug the appliance into a mains socket.
• Make sure the "tank full/tank missing" light is
off. If it is on, position the tank correctly.
• The dehumidifying standby light comes on
during the first three minutes (safety device),
then the appliance starts dehumidifying.
• The humidistat dial is used to adjust the
humidity level as desired (MIN/MED/MAX and
intermediate levels).
When the dial is on MIN, the dehumidifier
removes only a small amount of humidity
from the room. On MAX, it removes a large
amount of humidity.
To dehumidify, adjust the humidistat to one of
the positions available.
Dry mode (drying washing)
To remove a large amount of moisture (for
example when drying washing), you are
recommended to operate the appliance at
maximum power by turning the humidistat dial to
DRY.
In this mode, the dehumidifier operates
continuously, irrespective of the level of humidity
in the room.
To Next Page
Loading...
Need help?
General
