REASSEMBLY
1.
Install the selector shaft oil seal into the rear
cover.
2.
Insert the selector shaft spring and selector
finger into the rear cover.
3. Place the bellows on the selector shaft and
insert the shaft into the rear cover, spring and
selector finger.
4.
Install the rollpins securing the selector finger
to the shaft.
5. Compress the spring using Tool J28869 and
insert the two (2) half-bushes in each end of
the spring.
6. Install the rear cover plug using specified sealer
in accordance with its labelled precautions on
the threads.
PFej
(IS31
To Next Page
Loading...
