installed.
If
the cylinder bore is damaged, the
caliper must be replaced.
REASSEMBLY
1.
Lubricate cylinder bores and new sealing rings
with clean brake fluid and install sealing rings
into groove in the bore.
2.
For
ease of assembly, keep the dust covers dry
and do not lubricate.
3. Insert the piston into cylinder bore and install
the dust covers and retaining rings. Make
certain dust covers are correctly installed.
INSTALLATION
1.
Position the caliper to the hub assembly
ensuring shims originally removed between
the mounting faces are correctly positioned.
Torque to specification.
2.
Replace pads retaining pins and retaining pin
clips.
3. Reconnect brake pipe and bleed system.
4.
Install tyre and wheel assembly. Torque to
specification.
5. Lower car on hoist.
To Next Page
Loading...
