8
3. Turn off the radio and SKYFi2
Receiver. Disconnect all cables.
4. Find a place where you can mount
your SKYFi2 vehicle cradle where
it is most convenient for you to
use. It should be mounted to a
hard, flat surface below the top of
the dash within easy reach.
5. The SKYFi2 Vehicle Adapter Kit
has three mounting options: flat
mount, vent mount or swivel
mount.
a. Flat mount: Use the included
Velcro pads or extra adhesive
pad, attaching them to the back
of the SKYFi2 vehicle cradle
and then to a flat surface in
your vehicle. Do not install the
mount on a leather surface.
b. Vent mount: Assemble the
mount (if not assembled) by
inserting the two clips into
the main piece. Clip the
assembly onto the vent, and
then position the pivoting
kickstand atthe bottom. The
orientation of the clips must
match each other and may
need to be rotated in one of
two possible orientations
depending on the design of
the air vent being used. Be
careful when installing and
removing the vent mount
clips to prevent damaging
the vent fins.
English Skyfi2 install guide:SKYFi2 install guide layout 9/21/2006 12:09 PM Page 9
To Next Page
Loading...
Need help?
General
