Note: If using the XM SureConnect or the
professional wired (Delphi FM Direct
Adapter), set the SKYFi2 Receiver and the
vehicle’s FM radio to the same frequency. See
the
SKYFi2 User Guide
section on Listening
to XM using your vehicle’s FM Radio.
SKYFi2 Installation
Because every vehicle is different, these
instructions are provided as a general
guideline only. If you need help, consult
a professional installer.
1. Decide which method (cassette
adapter, professional wired FM, or
self install (XM SureConnect) is
most appropriate for your vehicle
and where you live.
2. Verify the system is working by
completing a test. Before installing
the system, connect the XM Antenna,
(If you are using the XM SureConnect
Installation you will need to install the
XM SureConnect before you will be
able to hear audio on you vehicle’s FM
Radio) 12V power adapter, and
audio connector or cassette adapter
(if used) to the SKYFi2 Vehicle
Adapter cradle with the SKYFi2
Receiver inserted. Plug the 12V
power adapter into the cigarette
lighter and place the XM Antenna
on the roof of your vehicle. Make
sure you are outdoors and not sur-
rounded by tall buildings or trees.
Turn on both your vehicle’s radio
and SKYFi2 Receiver. Tune the
SKYFi2 Receiver to XM channel 1.
You should be able to hear the XM
Preview channel. If not, check all
connections.
Warning: Do not install the mount where it
or SKYFi2 could block your vision or usage of
controls, or interfere with any safety devices
such as airbags. Failure to correctly place
SKYFi2 could result in injury to you or others if
the unit becomes detached during an accident
and/or obstructs the deployment of an airbag.
7
English Skyfi2 install guide:SKYFi2 install guide layout 9/21/2006 12:09 PM Page 8
To Next Page
Loading...
Need help?
General
