To Next PageTo Next Page
Need help?Do you have a question about the Delphi SkyFi2 SA10101 and is the answer not in the manual?
General| Type | Satellite Radio Receiver |
|---|---|
| Model | SA10101 |
| Brand | Delphi |
| Satellite Radio Service | Sirius |
| Compatibility | Sirius Satellite Radio |
| Display | LCD |
| Presets | 30 |
| Connectivity | Auxiliary input |
| Power Source | Rechargeable Battery |
| Audio Output | 3.5mm headphone jack |
Connect accessories to your SKYFi2 Cradle, including power and audio cables.
Recommended for vehicles with cassette players due to superior audio quality.
Provides audio input through the vehicle's antenna lead, may require special adaptors.
Allows XM programming broadcast on a local FM radio frequency for ease of use.
Overview of flat, vent, and swivel mount options for the SKYFi2 cradle.
Attaches the cradle to a hard, flat surface using included Velcro or adhesive pads.
Clips the cradle assembly onto a vehicle air vent, requires careful orientation.
Allows angle adjustment after installation; uses strong adhesive, requires surface preparation.
Instructions for routing the antenna cable along door jambs, through grommets, or into the trunk.
Connect the SKYFi2 Home Stand to power, antenna, and home stereo.
Steps to connect cables, position antenna, and test the system for home setup.
Guide to positioning the home antenna for optimal satellite signal strength.
Procedure for obtaining warranty service and required proof of purchase.
Information on how state laws may affect warranty rights and limitations.
