Delta Electronics EXIO14RAE - Page 13

Chapter 2 HMI-WPLSoft Introduction|DOP-EXIO Series
2-6
Revision March, 2008, Doc. Name: 2007PDD23000014
 Method 4: Right click the mouse to get a pop-up menu and select “Redo” in the
pop-up menu.
 Select All(A) Ö Select everything in a program file.
 Method 1: Click “Edit(E)” > “Select All (A)”.
 Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (A).
 Delete Ö Delete a selection (selected block or data) where the cursor is.
 Method 1: Click “Edit(E)” > “Delete”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing key (Delete).
 Method 4: Right click the mouse to get a pop-up menu and select “Delete” in the
pop-up menu.
 Cut(T) Ö Cut a selection (selected block or data) in a program file.
 Method 1: Click “Edit(E)” > “Cut(T)”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (X).
 Method 4: Right click the mouse to get a pop-up menu and select “Cut” in the
pop-up menu.
 Copy(C) Ö Copy a selection (selected block or data) from a program file.
 Method 1: Click “Edit(E)” > “Copy(C)”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (C).
 Method 4: Right click the mouse to get a pop-up menu and select “Copy” in the
pop-up menu.
 Paste(P) Ö Paste a selection (selected block or data) on a program file.
 Method 1: Click “Edit(E)” > “Paste(P)”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (V).
 Method 4: Right click the mouse to get a pop-up menu and select “Paste” in the
pop-up menu.