Delta Electronics EXIO14RAE - Page 14

Chapter 2 HMI-WPLSoft Introduction|DOP-EXIO Series
Revision March, 2008, Doc. Name: 2007PDD23000014 2-7
 Insert Block(O) Ö Insert a selection (selected block or data) into a program file (This
function is valid for Ladder Diagram Mode only.).
 Method 1: Click “Edit(E)” > “Insert Bock(O)”.
 Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Ins).
 Method 3: Right click the mouse to get a pop-up menu and select “Insert Block” in
the pop-up menu.
 Insert Row(I) Ö Insert a blank row into a program file.
 Method 1: Click “Edit(E)” > “Insert Row(I)”.
 Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (I).
 Method 3: Right click the mouse to get a pop-up menu and select “Insert Row” in
the pop-up menu.
 Delete Row(L) Ö Delete a row from a program file.
 Method 1: Click “Edit(E)” > “Delete Row(L)”.
 Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Y).
 Method 3: Right click the mouse to get a pop-up menu and select “Delete Row” in
the pop-up menu.
 Delete Vertical Line(D) Ö Delete the vertical lines from a program file(This function is
valid for Ladder Diagram Mode only.).
 Method 1: Click “Edit(E)” > “Delete Vertical Line(D)”.
 Method 2: Click the icon
on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (D).
 Method 4: Right click the mouse to get a pop-up menu and select “Delete Vertical
Line” in the pop-up menu.
 Program Title(S) Ö The information of program title, file name, company name and
designer are shown here and can be printed as an easy cover.
 Method 1: Click “Edit(E)” > “Program Title(S)”.
 Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Alt) + (T).