Chapter 2 HMI-WPLSoft Introduction|DOP-EXIO Series
Revision March, 2008, Doc. Name: 2007PDD23000014 2-9
Edit Device Comments(D) Ö Insert a comment for every operand of the device
where the cursor is positioned.
Method 1: Click “Comment(M)” > ” Edit Device Comments(D)”.
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Alt) + (D).
Method 3: Right click the mouse to get a pop-up menu and select “Edit Device
comments” in the pop-up menu.
Edit Segment Comments(B) Ö Insert a segment comment in the blank row (This
function is valid for Ladder Diagram Mode only.).
Method 1: Click “Comment(M)” > "Edit Segment Comments(B)”.
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Alt) + (B).
Method 3: Right click the mouse to get a pop-up menu and select “Edit Segment
Comments” in the pop-up menu.
Edit Row Comments(L) Ö Insert a row comment after output coil or instruction of
each row (This function is valid for Ladder Diagram Mode only.).
Method 1: Click “Comment(M)” > ” Edit Row Comments(L)”.
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Alt) + (L).
Method 3: Right click the mouse to get a pop-up menu and select “Edit Row
comments” in the pop-up menu.
2.5 Search
The “Search” function is shown as follows, including pull-down menu options:
To Next Page
Loading...
