Delta Electronics EXIO14RAE - Page 32

Chapter 3 Creating and Editing Programs|DOP-EXIO Series
Revision March, 2008, Doc. Name: 2007PDD23000014 3-11
Explanation Instruction Icon
Instruction Code
(Mnemonic Code)
Brevity Code Example
contact
Rising pulse LDP + LDP M0 or + M0
Falling pulse LDF – LDF M0 or – M0
Output coil OUT O OUT M0 or O M0
) Insert / Replace Mode
Using the “Insert” key on the keyboard can switch to the Insert Mode or the Replace Mode
when editing a ladder diagram.
 If the “Replace” word is displayed on the status bar, pressing the Insert key on the
keyboard is to switch to the Insert Mode. In the Insert Mode, insert a new ladder
diagram to where the editing block is located, and the original ladder diagrams
following the new diagram will shift one space to the right.
 If the “Insert” word is displayed on the status bar, pressing the Insert key on the
keyboard is to switch to the Replace Mode. In Replace Mode, inserting a new ladder
diagram can replace the original ladder diagram located in the editing block, and the
following other ladder diagrams will not be changed.
) Edit(E)
 Undo(U) Ö Undo the most recent actions (the system allows the user to perform undo
action for max. 10 times)
 Method 1: Click “Edit(E)” > “Undo(U)”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (Z).
 Method 4: Right click the mouse to get a pop-up menu and select “Undo” in the
pop-up menu.
 Redo(R) Ö Redo the undo action.
 Method 1: Click “Edit(E)” > “Redo(R)”.
 Method 2: Click the icon on the toolbar.
 Method 3: Use keyboard shortcuts by pressing keys (Ctrl) + (Alt) + (Z).
 Method 4: Right click the mouse to get a pop-up menu and select “Redo” in the
pop-up menu.