SAFETY INSTRUCTIONS SM15K-SERIES
3 / 8 DELTA ELEKTRONIKA B.V. rev. August 2019
11 Removal of (safety) covers
Safety cover(s) are used to cover potentially hazardous voltages.
Observe the following when removing safety cover(s):
Switch off the unit.
Disconnect the unit from the mains supply or power outlet.
Wait for 5 minutes to allow internal capacitors to discharge.
Unscrew the screws and remove the cover(s).
Always place the cover(s) back before connecting the unit to the mains supply again.
12 Environmental Conditions
The Delta Elektronika power supplies safety approval applies to the following operating conditions:
Indoor use
Ambient temperature : -20 to 50 °C
Maximum relative humidity : 95%, non condensing, up to 40 °C
: 75%, non condensing, up to 50 °C
Altitude : up to 2000 m
Pollution degree : 2
WEEE (Waste Electrical & Electronic Equipment)
1 Correct Disposal of this Product
Applicable in the European Union.
This marking shown on the product, its packing or its literature indicates that it should not be disposed with
other wastes at the end of its working life, but should be collected separately to recycle it responsibly to
promote the sustainable reuse of material resources.
To Next Page
Loading...
