ENGLISH
94
KEY SIMBOLS LIT BESIDES
THE NUMBERS
FUNCTION
DESCRIPTION
and Time values stored previously
are being erased from the
memory and a new series of
recordings is started which will be
used as the basis on which to cal-
culate and store the new Max.,
Min., Mean, Q and Time values.
After resetting of the Max., Min.,
Mean, Q and Time values, the
RCD function has a duration of
about 140,000 readings, that is
about 20 hours. At the end, the
RCD function is automatically
interrupted and the values calcu-
lated up till then are maintained.
During RCD mode the Auto
Power Off function is disabled.
Attention:
If the battery symbol does not fla-
sh at a frequency of 2 Hz when
the RCD key is pressed, it means
that the RCD function has stored
more than the allowed number of
readings and cannot continue any
further.
After having taken note of the
Max., Min., Mean, Q and Time
values calculated up till then, reset
the RCD function and restart it.
t
key. During programming or
calibration, this key is used to de-
crease the value of the parameter
being considered.
To Next Page
Loading...
