To Next PageTo Next Page
Need help?Do you have a question about the Delta 36-T30 T3 and is the answer not in the manual?
Explains safety symbols (DANGER, WARNING, CAUTION, NOTICE) for hazard recognition.
Warns about cancer, birth defects from dust exposure and suggests mitigation.
Covers eye/hearing protection, apparel, work area, maintenance, guards, and safe operation.
Describes the components of the 36-T30 T3 and 36-T50 T3 fence systems.
Details the hardware included in the main and additional packages for assembly.
Instructions for unpacking and cleaning the machine using appropriate solvents.
Step-by-step guide to install the front guide rail onto the table saw.
Steps to attach the rear guide rail to the table saw.
Instructions for re-attaching existing or adding new extension wings.
Guide to build a wooden table support for the 36-T50 T3 fence.
Instructions for attaching legs and leveling feet to the extension table.
Steps for connecting the extension table to guide rails and saw table.
Instructions for securing the guide tube to the front guide rail.
Steps for placing and locking the fence onto the guide tube.
How to align the fence parallel to the miter gauge slots.
Fine-tuning fence alignment using set screws for accuracy.
Procedure to ensure the fence is perpendicular to the table surface.
How to adjust the lever for secure fence clamping.
Steps to calibrate the fence scale pointer for accurate measurements.
Information on obtaining parts, service, and warranty assistance from DELTA.
Guidelines for cleaning the machine and its plastic parts.
Recommended lubrication for the fence and guide tube sliding surfaces.
How to protect the cast iron table surface from rust.
Warning about using non-DELTA accessories, recommending only approved ones.
Details coverage, period, exclusions, and how to obtain service.
General| Brand | Delta |
|---|---|
| Model | 36-T30 T3 |
| Category | Fencing & Gates |
| Language | English |
