What to do if my Delta 72045T has poor touch performance?
To resolve poor or inadvertent touch or proximity performance with your Delta Plumbing Product, clean and dry the base to remove excess water and soap from the base and contact clip. Also, ensure your hands or fingers are close enough to the spout to activate the proximity feature.
Why does my Delta 72045T Plumbing Product turn on by itself?
If your Delta Plumbing Product pump turns on when grabbing to rotate it off or when working in the sink area, it may be because you are approaching the unit too slowly. Try approaching it at a faster rate. Alternatively, you can disable the hands-free feature to prevent this.
What to do if my Delta 72045T Plumbing Product has no light?
If your Delta Plumbing Product has no activation or no light, the spout may not be securely on the base, creating a gap. Remove and replace the spout in the center position. Also, the spout may be rotated too far from the center, inadvertently turning the unit off; in this case, remove and replace the spout in the center position. If the light is still not on, remove the battery cap and reinstall it to reset the unit.
How to improve pump performance of Delta 72045T Plumbing Product?
If the pump performance of your Delta Plumbing Product is poor, the soap or lotion you are using may be too thick. You can increase the run time (see page 5) or add a small amount of water to the soap to improve its flow.
Why is there a red light on my Delta Plumbing Product with new batteries?
If your Delta Plumbing Product shows a red light with new batteries, you may have one or more batteries reversed. Check the battery orientation and correct it.
General| Brand | Delta |
|---|---|
| Model | 72045T |
| Category | Plumbing Product |
| Language | English |
Details the components included with the touch soap dispenser for different models.
Lists the necessary tools and supplies for installing the soap dispenser.
Explains how to activate the dispenser using hands-free or touch methods.
Differentiates between touch and grab for accurate activation and programming.
Describes how to activate and deactivate the hands-free feature using the spout.
Instructions on how to remove the spout to refill the soap reservoir.
Guide on how to change the amount of soap dispensed per activation.
How to turn off the dispenser by rotating the spout for easy cleaning.
Step-by-step guide to modify the factory set amount of soap dispensed.
Instructions on how to disable the automatic hands-free activation feature.
Details on parts and initial mounting of the dispenser base to the sink.
Instructions for connecting the soap bottle and electrical wiring.
Covers filling the dispenser reservoir and attaching the spout correctly.
Guide on inserting and aligning the batteries for power.
Explains normal operation, LED indicators, and low battery warnings.
Addresses issues like red light, poor pump performance, no activation, and inadvertent activation.
Lists components for the 72045T model.
Lists components for the 72065T model.
Lists components for the 72055T model.
Identifies shared components across all "T" model dispensers.
Outlines coverage for parts, finishes, and electronic components for consumers and commercial use.
Specifies limitations, exclusions, and conditions not covered by the warranty.
Instructions on how to claim warranty service or obtain replacement parts.
To Next Page
