5.5.2 Starting Addresses for Analog Input/Output Modules
HWCONFIG automatically assigns input and output data registers to an analog input/output module in ISPSoft
according to the number of registers defined for the analog input/output module. The default starting address
is D29000.
1. 04AD: There are four input channels. The input device range occupies 20 data registers.
2. 08AD: There are eight input channels. The input device range occupies 20 data registers.
3. 004DA: There are four output channels. The input device range occupies two data registers and the
output device range occupies 18 data registers.
4. 06XA: There are four input channels, and two output channels. The input device range occupies 10 data
registers, and the output device range occupies 10 data registers.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
