5. Clean the nozzle using the nozzle cleaner provided or a straightened paper
clip. Insert into the nozzle end and work back and forth until obstruction is
removed.
6. Direct water supply into nozzle end to backflush loosened particles for 30
seconds.
7. Plug unit into appropriate outlet.
8. Reassemble the nozzle to the wand. Tighten securely to prevent leaks.
9. Reconnect wand to gun and turn on water supply.
10. Start pressure washer and place wand into high pressure setting to test.
14- ENG
D29382
To Next Page
Loading...
