How to check the signal strength on Delta Thermostat?
To verify the signal strength on your Delta Thermostat, check the signal strength from the router and the wireless thermostat. See the AV94 (WiFi_RSSI) entry in the Object Instances Numbers table in the Database Objects section.
What to do if I changed password but unable to log in from the Configuration Menu on Delta Thermostat?
If you changed the password on your Delta Thermostat but are unable to log in from the Configuration Menu, note that for the keypad PIN, each digit must be either 0 or 1. The AV531 object in the eZNT-Wi/ eZNTW database contains the password. The password cannot be changed in the webpage.
How to access service port on Delta Thermostat?
To access the service port on your Delta Thermostat, verify that the USB port is enabled in either the on-screen configuration menu or the configuration webpage.
How to load a GWT .pob file on Delta Thermostat?
To load a GWT .pob file on your Delta Thermostat, be sure to use enteliZONE GWT objects and not the older DAC GWT objects.
General| Model | eZNT-Wi Series |
|---|---|
| Type | Thermostat |
| Connectivity | Wi-Fi |
| Display | LCD |
| Power Supply | 24 VAC |
| Operating Temperature | 0°C to 50°C |
| Humidity Range | 5% to 95% non-condensing |
| Weight | 150 g |
| Certifications | CE, FCC, UL |
Details the eZNT-Wi as a BACnet/IP wireless Wi-Fi product with local I/O.
Lists essential passwords for Wi-Fi configuration.
Explains Wi-Fi concepts specific to eZNT-Wi/eZNTW-Wi.
Details default MAC addresses for Wi-Fi devices.
Explains the AP Host Mode (IPS2) for Wi-Fi.
Explains the Station Client Mode (IPS1) for Wi-Fi.
Configuring Wi-Fi using NFC and Net Builder app.
Configuring Wi-Fi via the built-in webserver.
Configuring Wi-Fi settings using enteliWEB.
Solutions for common Wi-Fi problems.
How to navigate and configure using the on-screen menu.
Restoring default factory settings using the RUN/CLEAR jumper.
How to tap and read configuration data via NFC.
Writing device settings using the Stat Configurator app.
Procedures for manual calibration of the CO2 sensor.
Calibrating the CO2 sensor via the on-screen menu.
Calibrating the CO2 sensor using enteliWEB/ORCAview.
Auto-calibrating the CO2 sensor via the on-screen menu.
Installing Delta eZNx driver to create a virtual COM port.
To Next Page
