EN
9
For elevation adjustment, turn the elevation adjustment screw
clockwise to lower the point of impact and counterclockwise to
raise the point of impact. For windage adjustment, turn windage
adjustment screws clockwise to move the point of impact to the
left and counterclockwise to move the point of impact to the
right . (Fig. 4)
Fig. 4
If a large amount of adjustment is required to align the reticle,
make approximately one-half of the required windage correction,
then approximately one-half of the required elevation correction.
Finish by applying the balance of windage and elevation correction.
Note: one click of adjustment changes bullet strike at a shooting
distance of 100 meters by 0,1 mrad - 10mm on models with
reticles LRD-1T, LRD-1P, DLR-1, or by 0,05 mrad - 5mm on
models with reticles DLS-1, DLS-2, or by 1/8 MOA – 3.5mm on
model with reticle DLS-3
To Next Page
Loading...