Delta VFD110ED43S - Page 273

12 Descriptions of Parameter Settings | VFD-ED
12-02-2
Multi-function Input Command 5 (MI5)
Default: 0
Multi-function Input Command 6 (MI6)
Default: 0
Multi-function Input Command 7 (MI7)
Default: 0
Multi-function Input Command 8 (MI8) (Enable Drive terminal)
Default:40
Settings Control Mode VF VFPG SVC FOCPG FOCPM
0: No function
○ ○ ○ ○ ○
1: Multi-step speed command 1
○ ○ ○ ○ ○
2: Multi-step speed command 2
○ ○ ○ ○ ○
3: Multi-step speed command 3
○ ○ ○ ○ ○
4: Multi-step speed command 4
○ ○ ○ ○ ○
5: Reset
○ ○ ○ ○ ○
6: JOG command
○ ○ ○ ○ ○
7: Acceleration/deceleration speed inhibit
○ ○ ○ ○ ○
8: First, second acceleration/deceleration time
○ ○ ○ ○ ○
9: Third, fourth acceleration/deceleration time
○ ○ ○ ○ ○
10: EF input (Pr.07-28)
○ ○ ○ ○ ○
11: Reserved
12: Stop output
○ ○ ○ ○ ○
13–14: Reserved
15: AUI1 operation speed command
○ ○ ○ ○ ○
16: Reserved
○ ○ ○ ○ ○
17: AUI2 operation speed command
○ ○ ○ ○ ○
18: Emergency Stop (Pr.07-28)
○ ○ ○ ○ ○
19–23: Reserved
24: FWD JOG Command
○ ○ ○ ○ ○
25: REV JOG Command
○ ○ ○ ○ ○
26: Reserved
27: ASR1/ASR2 selection
○ ○ ○ ○ ○
28: Emergency stop (EF1) (motor coasts to stop)
○ ○ ○ ○ ○
29–30: Reserved
31: High torque bias (according to Pr.07-21)
○ ○ ○ ○ ○
32: Middle torque bias (according to Pr.07-22)
○ ○ ○ ○ ○
33: Low torque bias (according to Pr.07-23)
○ ○ ○ ○ ○
34–37: Reserved
38: Disable writing to EEPROM
○ ○ ○ ○ ○
39: Torque command direction (0 is positive
direction)
40: Enable drive function
○ ○ ○ ○ ○