Delta VFD11AMS23ANSAA - Page 166

Chapter 8 Option CardsMS300
157
Environment
Noise Immunity
ESD (IEC 61800-5-1, IEC 6100-4-2)
EFT (IEC 61800-5-1, IEC 6100-4-4)
Surge Test (IEC 61800-5-1, IEC 6100-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 6100-4-6)
Operation / Storage
Operation: -10–50ºC (temperature), 90% (humidity)
Storage: -25–70ºC (temperature), 95% (humidity)
Shock / Vibration
Resistance
International standards:
IEC 61131-2, IEC 68-2-6 (TEST Fc) / IEC 61131-2 & IEC 68-2-27(TEST Ea)
Table 8-8
8-2-4 Installation
PROFIBUS DP Connector
PIN
Signal
Definition
1
6
5
9
Figure 8-26
1
-
Not defined
2
-
Not defined
3
Rxd / Txd-P
Sending / receiving data P(B)
4
-
Not defined
5
DGND
Data reference ground
6
VP
Power voltage – positive
7
-
Not defined
8
Rxd / Txd-N
Sending / receiving data N(A)
9
-
Not defined
Table 8-9
8-2-5 LED Indicator & Troubleshooting
There are two LED indicators on the CMM-PD02: POWER LED and NET LED. POWER LED displays
the status of the working power. NET LED displays the connection status of the communication.
POWER LED
LED Status
Indication
Corrective Action
Green light ON
Power supply in normal status.
No action is required.
OFF
No power
Check if the connection between the CMM-PD02
and the AC motor drive is normal.
Table 8-10
NET LED
LED Status
Indication
Corrective Action
Green light ON
Normal status
No action is required.
Red light ON
The CMM-PD02 is not connected to
PROFIBUS DP bus.
Connect the CMM-PD02 to the PROFIBUS DP bus.
Red light
flashes
Invalid PROFIBUS communication
address
Set the PROFIBUS address of the CMM-PD02
between 1–125 (decimal).
Orange light
flashes
The CMM-PD02 fails to
communicate with the AC motor
drive.
Switch off the power and check whether the CMM-
PD02 is correctly installed and normally connected
to the AC motor drive.
Table 8-11